Home  >  Cabinet Organizers > Installation Instructions (Door Storage Shelf Sets)
 

Cabinet Organizers - Installation Instructions for
  Door Storage Shelf Sets

The DOOR STORAGE UTILITY TRAYS will work perfectly on wood or melamine doors, pegboard units and various other convenient applications. It requires simple installation and provides double level storage with as little as 4-1/2" clearence from the back of door to front of tray.

Tools Required: (Screw-In Clip Installation Only) Soft Lead Pencil (For marking screw locations) Drill with a 3/32" Diameter Drill Bit #2 Phillips Screwdriver Any kind of Tape Tape Measure or Level may be desired .

STEP 1		STEP 2
Screw-In Clip Installation - Snap one clip into the slot at each end of the tray. Hold the shelf in place and mark the screw locations using the upper holes in each clip. Note: Before marking the screw locations, you may want to use a level or tape measure to insure that the tray is straight.		Remove the clips from the tray by disengaging spring hook as shown. Using 3/32" drill bit, prepare to drill pilot holes at locations marked in Steps 1 & 3. Wrap tape 5/16" from tip of drill bit as shown. Drill two holes at locations marked in Step 1 (do not drill deeper than front edge of tape). Mount clips at top holes using two (2) 1/2"x#6 scews (do not fasten securely).
STEP 3		STEP 4
With clips in vertical position, mark bottom hole locations (swing clip to allow for drilling) and drill remaining pilot holes. Reposition the clips and securely mount top and bottom of each clip using two (2) 1/2" #6 screws. Note: Use plastic screw anchors or #6-32 toggle bolts (available at your local hardware store) when installing Screw-In Clips on wall-board, plaster or very thin material.		Position the tray on the clips and gently press downward to engage spring lock. This completes the installation of your Door Storage Utility Tray. To install second Door Storage Utility Tray simply repeat Steps 1-4.